SECOND ATTEMPT

Second attempt on metal sheet fabrication

Elevation of the metal 

Section of the metal

Use the cylinder tool and wooden hammer，first of all, how to start. If I make whole of it it will too diffcult, then seperate into two parts. In this case, cut out a fan-shape metal sheet. Hold it on the cylinder tool, blend it around the cylinder. Once you has the intial shape, use the template to find the transition line, mark it, hold the tail of the metal sheet, follow the line smash it on, do it several times. It will start to stretch and slowly forming. Once it start to curve up, would have wrinkles. Then need to use the steel hammer stretch on both side. Hit it slowly, keep it flat and tight on the cylinder.

If you want to get the beautiful curve line, you need to do bit adjustment. 

Use the steel hammer, put the metal on that round iron start to tide up get the smooth curve line.

For the head part, repeat the same technique that I show on the first attempt. More importantly, need to check the metal sheet whether suit the template or not. 

Use the marker pan draw line on the excess part, use the scissors to cut off the excess part. 

Finally, in second attempt, I create the metal sheet suit the template perfectly. But one of the mistake I made that is cutting too much excess part off, the metal sheet head can not shrink all around the head.